Original Article
  • High Temperature Tensile Stress Behavior of Hydrogen Vessel Composite Materials for Hydrogen Fuel Cell Bus
  • Hyunseok Yang*, Woo-Chul Jung*, Kwang Bok Shin**, Man-Sik Kong*†

  • * Center for Advanced Materials & Processing, Institute for Advanced Engineering, Yongin, Korea
    ** Department of Mechanical Engineering, Hanbat National University, Daejeon, Korea

  • 수소버스용 내압용기 복합재의 열적환경에 따른 기계적 물성 연구
  • 양현석*· 정우철*· 신광복**· 공만식*†

  • This article is an open access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/by-nc/4.0) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

In this study, the mechanical properties of the pressure vessel composite exposed to the thermal environment were evaluated to establish the standard for high temperature static pressure test of the pressure vessel for hydrogen bus. As the tensile strength of the composite material approaches the glass transition temperature of the epoxy resin, the strength decreases due to the deterioration of the epoxy resin. In addition, it was confirmed that the tensile strength increased again due to the post-curing of the epoxy resin during long-term exposure. Therefore, the accelerated stress rupture test conditions of the pressure vessel for the hydrogen bus should be set based on the epoxy resin properties of the carbon fiber composite material


수소가스용 압력용기의 안전성 평가를 위해 다양한 내구성 시험이 요구된다. 고온 정압 시험은 고압(875 bar) 하에 고온(85oC 이상)에서 장시간(1,000시간) 유지하여 수소 용기의 내구성을 시험하는 방법이며 승용차용 용기에 한정되어 있다. 하지만 대용량 수소버스용 용기와 관련된 고온 정압 시험의 국제 기준은 논의 초기 단계이며, 시험의 효율성 및 신뢰성 측면에서 가속시험 기준 제시 등의 현실적 보완이 필요하다. 본 연구에서는 수소버스용 내압용기의 고온 정압 시험 기준을 정립하기 위해 열적환경에 노출된 내압용기 복합재의 기계적 물성평가를 진행하였다. 복합재의 인장강도는 수지의 유리전이온도에 가까워질수록 수지의 열화로 인해 강도가 감소한다. 또한 장시간 유지 시 수지의 후경화로 인해 인장강도의 재상승을 확인할 수 있었다. 따라서 대용량 수소버스용 압력용기의 고온 정압 시험은 탄소섬유 복합재의 에폭시 수지 물성을 바탕으로 시험 조건을 설정해야 한다


Keywords: 복합재 내압용기(Composite Pressure Vessel), 수소버스(Hydrogen Fuel Cell Bus), 고온 정압 시험(High Temperature Static Pressure Test), 열적환경(Thermal Environments), 인장강도(Tensile Strength)

This Article

Correspondence to

  • Man-Sik Kong
  • Center for Advanced Materials & Processing, Institute for Advanced Engineering, Yongin, Korea

  • E-mail: mskong@iae.re.kr