Original Article
  • A Study on the Development of Textile Electrodes for Body Contact Sensing for High-reliability Smartwear

  • Jong-hyun Joo*, Seong-Hwang Kim*, Hye-ji Jeon*, Ju-Ra Jeong*, Jin-seok Bae**† , Ri-ra Kim***†

  • * Korea Institute of Convergence Textile (KICTEX)
    ** Department of Textile System Engineering, Kyungpook National University, Daegu 37224, Korea
    *** Corresponding author (E-mail: jbae@knu.ac.kr) Department of Lifestyle Design, Yuhan University, Korea

  • This article is an open access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/by-nc/4.0) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.


References
  • 1. Ning, Q.G., and Chou, T.W., “A Closed-Form Solution of the Transverse Effective Thermal Conductivity of Woven Fabric Composites,” Journal of Composite Materials, Vol. 29, No. 29, 1995, pp. 2280-2294.
  •  
  • 2. Park, Y.B., Yang, H.J., Kweon, J.H., Choi, J.H., and Cho, H.I., “Failure of Composite Sandwich Joints under Pull-out Loading,” Journal of the Korean Society for Composite Materials, Vol. 24, No. 1, 2011, pp. 17-23.
  •  
  • 3. Vinson, J.R., The Behavior of Sandwich Structures of Isotropic and Composite Materials, Technomic Pub. Co., Lancaster, UK, 1999.
  •  
  • 4. Jeong, K.W., Park, Y.B., Choi, J.H., and Kweon, J.H., “A Study on Failure Strength of Composite Key Joint,” Proceeding of the 8th Korea-Japan Joint Symposium on Composite Materials, Changwon, Korea, Nov. 2011, pp. 36-38.
  •  
  • 5. Cartié, D.D.R., Effect of Z-fibresTM on the Delamination Behaviour of Carbon Fibre/epoxy Laminates, Ph.D Thesis, Cranfield University, UK, 2000.
  •  
  • 6. Kim, H.L., Rho, S.H., and Lim, D.Y., “Characterization of Embroidered Textile-based Electrode for EMG Smart Wear according to Stitch Technique,” Journal of Fashion and Textiles, Vol. 10, No. 1, pp. 1-19, 2023.
  •  
  • 7. Kim, H.L., Rho, S.H., and Lim, D.Y., “Fabrication of Textile-Based Dry Electrode and Analysis of Its Surface EMG Signal for Applying Smart Wear,” Journal of Polymers, Vol. 14, No. 17, 3641, 2022.
  •  
  • 8. Kim, S.Y., and Lim, G.Y., “Current Status of International Standardization for Durability Test Methods in Smart Clothing and Future Challenges in Enhancing Product Reliability and Quality Control,” Fashion and Textile Research Journal, Vol. 25, No. 3, pp. 398-408, 2023.
  •  
  • 9. Finni, T., Hu, M., Kettunen, P., Vilavuo, T., and Cheng, S., “Measurement of EMG Activity with Textile Electrodes Embedded into Clothing,” Journal of Physiological Measurement, Vol. 28, No. 11, pp. 1405-19, 2007.
  •  
  • 10. Kim, S.J., Kim, S.U., and Kim, J.Y., “Resistive E-band Textile Strain Sensor Signal Processing and Analysis Using Programming Noise Filtering Methods,” Journal of Korean Society for Emotion and Sensibility, Vol. 25, pp. 67-78, 2022.
  •  
  • 11. Bauer, G., Pan, Y.J., and Adamson, R., “Analysis of a Low-cost Sensor Towards an Emg-based Robotic Exoskeleton Controller,” Proceedings of the Canadian Society for Mechanical Engineering international Congress, Dalhousie University, Canada, 2018.
  •  
  • 12. Laferriere, P., Lemaire, E.D., and Chan, A.D., “Surface Electromyographic Signals Using Dry Electrodes,” Journal of IEEE Transactions on Instrumentation and Measurement, Vol. 60, pp. 3259-3268, 2011.
  •  

This Article

Correspondence to

  • Jin-seok Bae ** , Ri-ra Kim ***

  • ** Department of Textile System Engineering, Kyungpook National University, Daegu 37224, Korea
    *** Corresponding author (E-mail: jbae@knu.ac.kr) Department of Lifestyle Design, Yuhan University, Korea

  • E-mail: jbae@knu.ac.kr, rira8101@yuhan.ac.kr