Original Article

Preparing of Carbon Fiber Composites Using by Vacuum Bag Hot-press Molding Process and Comparison with the other Molding Processes
Won-Wook Heo*^†, Gil Woo Jeon**, Seung Kook An*
* Department of Organic Material Science and Engineering, Pusan National University
** Korea Textile Development Institute
진공백 핫 프레스 성형공정을 이용한 탄소섬유 복합재료의 제조와 공정비교
허원욱*^† · 전길우** · 안승국*

References

1. Kim, J.S., Kim, B.H., and Joe, C.R., “Development and Analysis of the Autoclave Alternative Composite Material Molding Process Using a Pressure Device”, Composite Research, Vol. 27, No. 6, 2014, pp. 254-259.
2. Grunenfelder, L.K., Centea, T., Hubert, P., and Nutt, S.R., “Effect of Room-temperature Out-time on Tow Impregnation in an Out-of-autoclave Prepreg”, Composites: Part A, Vol. 45, 2013, pp. 119-126.
3. Centea, T., Grunenfelder, L.K., and Nutt, S.R., “A Review of Out-of-autoclave Prepregs – Material Properties, Process Phenomena, and Manufacturing Considerations”, Compoistes: Part A, Vol. 70, 2015, pp. 132-154.
4. Thorﬁnnson, B., and Biermann, T., “Degree of Impregnation of Prepregs – Effects on Porosity”, Proc 32nd int SAMPE Symp. Anaheim, CA: Society for the Advancement of Material and Process Engineering; 1987, p. 9.
5. Juska, T.D., Musser, B.S., Jordan, B.P., and Hall, J.C., “The New Infusion: oven Vacuum Bag Prepreg Fabrication”, Proc SAMPE 2009 Conf. Baltimore, MD: Society for the Advancement of Material and Process Engineering, 2009.
6. Yoon, B.I., “Effect of Fiber Volume Fraction on the Mechanical Properties in Carbon Fiber-Epoxy Composites”, Polymer Society of Korea, Vol. 12, No. 7, 1988, pp. 619-626.
7. Moon, Y.J., “A Study on the Shape of the Fiber-reinforced Composite Material According to the Durability and Mechanical Proper-ties”, Ph.D Thesis, Pukyong University, Korea, 2011.

Won-Wook Heo
Department of Organic Material Science and Engineering, Pusan National University
E-mail: das77@daum.net