Original Article
  • Impact of Fiber Projection from GMT-Sheet Moldings on Surface Unevenness
  • Hyoung-Seok Kim*, Jin-Woo Kim**, Yong-Jae Kim***, and Dong-Gi Lee****+
  • GMT-Sheet 성형품의 표면요철에 미치는 섬유돌출의 영향
  • 김형석(조선대학교 대학원 첨단부품소재공학과), 김진우(광주테크노파크 차세대자동차전장부품생산지원센터), 김용재(조선대학교 전기공학과), 이동기(조선대학교 메카트로닉스공학과)
Abstract
According to the evaluation on GMT-sheet by molding conditions, fiber projection on the moldings surface was investigated. Fiber projection is one of the major defects on moldings surface due to matrix shrinkage. That is, fiber projection happens from different shrinkage of matrix and glass fiber. Height of fiber projection from moldings surface becomes smaller when molding pressure is higher during holding pressure and cooling process. Height of fiber projection is dominantly affected by molding pressure. With consideration of molding pressure, the formation of surface unevenness and change in fiber projection height was elucidated. In addition, coating layer is effective to suppress surface defects, and there is no fiber projection or crack in case that coating is applied. Coating layer improves surface roughness up to the level of the polypropylene which is a single material.

성형조건에 따른 GMT-Sheet를 관찰하여, 성형품 표면의 섬유돌출을 조사했다. 섬유돌출은 모재의 수축에 의해서 성형품 표면에 생성되는 불량현상의 하나이다. 즉, 섬유돌출은 성형온도에서 상온까지 성형품이 냉각될 때 모재와 유리섬유의 수축차에 의해 발생하는 표면불량 현상이다. 성형품 표면의 섬유돌출 높이는 보압·냉각과정에서 성형압력이 클수록 작게 나타남을 알 수 있다. 성형품 표면의 섬유돌출 높이는 성형압력의 영향이 지배적임을 알 수 있다. 성형압력을 고려하여, 성형품의 표면요철 생성과정과 섬유돌출 높이 변화를 규명했다. 그리고 피복층은 표면불량 현상을 억제하는 효과가 있고, 표면으로부터 섬유돌출이나 크랙이 보이지 않았다. 피복층은 표면거칠기를 단일재료인 폴리프로필렌 정도까지 개선하였다.

Keywords: GMT-Sheet moldings, Surface roughness, Surface unevenness, Fiber projection, Coating layer

Keywords: GMT-Sheet 성형품, 표면거칠기, 표면요철, 섬유돌출 , 피복층

This Article

  • 2011; 24(6): 31-36

    Published on Dec 31, 2011

Correspondence to

  • E-mail: