Sang-Youl Lee*†
* School of Civil, Environmental and Architectural Engineering, Gyeongkuk National University
이상열*†
This article is an open access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/by-nc/4.0) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.
This study evaluates the tensile properties of D13 glass fiber reinforced polymer (GFRP) bars incorporating carbon fibers near the surface and examines a material-level reinforcement area indicator. Five specimens were tested for each nominal mass-based carbon-content group of 0, 4.5, and 9.1%. The mean tensile modulus increased from 51.89 GPa to 56.75 and 62.45 GPa, representing gains of 9.36 and 20.36%, respectively. The hybrid groups retained 98.15 and 94.03% of the reference mean tensile strength, and 98.45 and 79.77% of its mean rupture strain. Recorded stress–strain curves and post-failure photographs indicate changes in load-carrying response and longitudinal splitting; they do not establish the sequence of microscopic interfacial damage. Under an idealized equal-axial-stiffness condition, the measured modulus ratios give calculated area reductions of 8.56 and 16.92%. These values are indicators for evaluating design possibilities, not verified reductions in reinforcement demand, member deflection, or crack width. Bond, member behavior, long-term performance, and the effects of constituent proportions and manufacturing conditions require further investigation.
본 연구에서는 표면부에 탄소섬유를 복합화한 D13 GFRP 보강근의 인장특성을 평가하고, 동일 축강성에 기초한 재료 수준의 보강면적 지표를 검토하였다. 공칭 중량기준 탄소 함유량 0, 4.5 및 9.1%에 대해 군당 5개를 시험하였다. 평균 탄성계수는 51.89 GPa에서 56.75 및 62.45 GPa로 증가하여 기준군 대비 9.36 및 20.36% 향상되었다. 하이브리드군의 평균 인장강도 유지율은 각각 98.15 및 94.03%, 파단변형률 유지율은 98.45 및 79.77%였다. 응력–변형률 곡선 및 파단 사진에서 하중지지 거동의 변화와 종방향 섬유 분리를 확인하였으나 미시적 계면 손상의 선후관계는 규명하지 않았다. 동일 축강성을 가정한 계산상 보강면적 감소율은 8.56 및 16.92%였다. 이는 설계 가능성 검토 지표이며 실제 배근량, 처짐 또는 균열폭의 감소율을 의미하지 않는다. 부착성능, 부재 거동, 장기성능 및 구성재 비율과 제조조건의 영향에 대한 추가 검증이 필요하다.
Keywords: 하이브리드 보강근(Hybrid reinforcing bar), 탄소섬유(Carbon fiber), 인장 탄성계수(Tensile modulus), 사용성(Serviceability)
This Article2026; 39(5): 593-599
Published on Oct 31, 2026
Correspondence toSchool of Civil, Environmental and Architectural Engineering, Gyeongkuk National University