Junmyeong Jang*, Seongho Jeon*, Suwon Bae*†
* School of Mechanical Engineering, Pusan National University
장준명* · 전성호* · 배수원*†
This article is an open access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/by-nc/4.0) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.
Molecular dynamics simulations were conducted to investigate the glass transition and tensile behavior of pure polyethylene (PE) and the influence of a reinforcing nanoparticle. The glass transition temperature was determined from the change in the slope of the volume–temperature relationship during cooling. Uniaxial tensile simulations were subsequently performed over a range of temperatures and strain rates. Increasing temperature reduced the Young’s modulus and tensile stress, whereas increasing strain rate generally enhanced the mechanical response. The nanoparticle did not consistently improve the initial modulus under all conditions but produced higher stresses and more pronounced strain hardening at large strains. Energy-component analysis indicated that nanoparticle incorporation altered the balance between nonbonded interactions and chain conformational rearrangement during deformation. Because molecular dynamics simulations employ cooling and strain rates substantially higher than those used experimentally, quantitative comparisons require caution. The proposed framework can support the interpretation and design of more realistic polymer nanocomposites.
본 연구에서는 분자동역학 시뮬레이션을 이용하여 순수 폴리에틸렌의 유리전이 거동과 온도 및 변형률 속도에 따른 기계적 특성을 분석하고, 보강 나노입자가 인장 거동에 미치는 영향을 조사하였다. 냉각 시뮬레이션과 온도–부피 관계를 이용하여 순수 폴리에틸렌의 유리전이온도를 산정하였다. 일축 인장 시뮬레이션 결과, 온도가 증가할수록 영률과 인장응력이 감소한 반면, 변형률 속도가 증가할수록 응력 수준은 대체로 증가하였다. 보강 나노입자는 초기 영률을 모든 조건에서 일관되게 향상시키지는 않았으나, 큰 변형률 영역에서 순수 폴리에틸렌보다 높은 응력과 뚜렷한 변형경화를 유도하였다. 에너지 성분 분석에서는 나노입자의 도입으로 비결합 상호작용과 사슬 형태 변화 사이의 에너지 분배가 달라지는 것을 확인하였다. 본 결과는 시뮬레이션과 실험의 시간 규모 차이를 고려하여 해석해야 하며, 제안된 방법론은 고분자 나노복합재료의 해석과 설계에 활용될 수 있다.
Keywords: 고분자 복합재료(Polymer composites), 분자동역학(Molecular dynamics), 유리전이온도(Glass transition temperature), 변형률 속도(Strain rate)
This Article2026; 39(5): 472-482
Published on Oct 31, 2026
Correspondence toSchool of Mechanical Engineering, Pusan National University